Home > Error Code > Ibm Ultrium Hh4 Error Codes

Ibm Ultrium Hh4 Error Codes

Contents

Server or workstation with a single disk (spindle) POOR. NOTE: Many backup applications use their own drivers. While holding the paper clip, have a second person attempt to pull the magazine out of the front of the unit (see Figure 3). At the end of the project, we also migrated all building security systems with it. have a peek here

Use the equivalent on a RISC or other type of processor. If there is a combination of LVD and SE devices on the bus, the maximum cable length reverts to the SE specification, which for Ultra devices is 10 feet (3 meters) If the ping fails, verify that the device has a valid network address and that there are no firewalls or other obstructions to network traffic between the computer with the web Make sure the device is connected to an LVDS SCSI bus and no SE devices are on the same bus, because this causes all the devices on the bus to slow http://www.ibm.com/support/knowledgecenter/STCMML8/com.ibm.storage.ts3500.doc/opg_3584_a69m4bfs0.html

Ibm Ultrium Hh4 Error Codes

LTO-3: GOOD. Also, if any SE devices are on the same SCSI bus, all of the devices on the bus slow down to SE speed, which severely degrades performance. If the application software or operating system detects the tape drive, but not the Autoloader: Verify that multiple LUN support is enabled on the HBA. The system returned: (22) Invalid argument The remote host or network may be down.

  1. Make sure that the cartridge is compatible with the drive.
  2. LTO-3: MARGINAL.
  3. The bus would be saturated with 2:1 compressible data.
  4. In Services, right-click Removable Storage and select Stop.
  5. Generated Sun, 30 Oct 2016 23:53:25 GMT by s_wx1199 (squid/3.5.20) ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: http://0.0.0.7/ Connection
  6. In this case, you may have to perform an erase, format, or label operation on the cartridge.
  7. NOTE: For an online troubleshooting tool, go to www.hp.com/support/MSLG3Tstree .
  8. Do not degauss Ultrium cartridges!
  9. Works fine usually but once in a while I get a "2" on the LED read out and an orange flashing light.

For example, use a cleaning cartridge for cleaning. If the average file size is less than 64 kb or if the file system is very fragmented, file-by-file backup will have poor performance. top Disk image, flash, or sequential Performance impact: GOOD. Ibm Tape Drive Error Codes If you can restore a single file, the restore process will be slow.

Check all SCSI and power connections and confirm that the unit is attached to a valid SCSI SE or LVDS bus. top top Connection from the host server to the Autoloader For the best performance, the connection from the host server to the Autoloader must have enough bandwidth to provide enough data If there are no bottlenecks and the Autoloader starts having performance problems: Try a new cartridge. It could be a defective cartridge.

A marginal cartridge can cause performance problems when the tape drive has to retry writing to bad spots on the tape. Ibm Lto 5 Tape Drive Error Code 6 If the failure follows the tape cartridge, the tape cartridge is probably at fault. Try another working outlet. Retry the operation with a different, known good tape.

Ultrium 3 Tape Drive Error Codes

Performance impact of various disk connections Connection type Performance impact Recommendations Fibre: 1 GB LTO-2: GOOD. Pay particular attention to any steps describing configuration settings. Ibm Ultrium Hh4 Error Codes Make sure that the proper device driver is installed for the SCSI host adapter. Certance Ultrium 2 Upgrade the Autoloader firmware to the latest release.

top Operation problems Power Problems Problem Solution Device does not power on. http://fullflash.net/error-code/midmark-m9-error-codes.html The drawback with concurrency or multithreading is that it slows the restore operation. When fully used and assuming that the connection to the disks does not force the speed to a lower parallel SCSI type, an Ultra 320 connection can provide enough bandwidth for The STOP sign icon and the word Crit before the event ID also indicate a hard error. Hp Ultrium 2 Scsi

When fully used, a 2 GB fibre connection can provide enough bandwidth for 4 LTO-2 tape drives. Disk arrays typically provide excellent access to data. Verify that the label is properly applied. http://fullflash.net/error-code/vpn-error-codes.html Generate a detailed support file that can be e-mailed or faxed to a support representative for analysis.

Make sure that all SCSI devices on the same bus have unique SCSI ID numbers. Ibm Tape Library Error Codes Help Desk » Inventory » Monitor » Community » Sign-in Register Site help Skip to ContentSkip to FooterSolutions Transform to a Hybrid Infrastructure Protect Your Digital Enterprise Empower the Data-Driven Organization For backups with an average file size <64 kb, HP recommends using a sequential/image backup that backs up the hard drive or LUN image instead of the individual files.

Third, have you tried a firmware update?   Thanks, James Braunstein I.T Administrator 0 Jalapeno OP Teplcon Oct 12, 2011 at 12:01 UTC Cyscore, Thanks for the input!

See the network administrator for help. If the parallel SCSI cables are not designed for Ultra 320 speeds or more than a couple devices are on the parallel SCSI bus, the bus may slow down to Ultra The request cannot be fulfilled by the server The request cannot be fulfilled by the server Home Ultrium LTO-2 error codes? Ibm Ultrium-hh3 Status Lights Figure 6: Error message in the OCP Error Log If you press Next, the OCP will display additional information, if available, as shown in No additional information in the OCP error

Make sure you are using an Ultrium universal cleaning cartridge (see the Tape cartridges section in Tape Cartridges and Magazines ). Some tapes need to be inserted and removed several times to condition them for free movement in and out of the magazine. SCSI bus not properly terminated (see SCSI Installation problems ). this contact form Do not use cartridges that are incompatible with the tape drive.

The HP Library & Tape Tools diagnostic provides an intuitive graphical user interface with integrated context-sensitive help. Expand the event for more information, as shown in Critical event details (Figure 11). No I don't have a new cleaning cartridge, but I just ordered one! The disadvantage is that backup and restore operations work on an entire disk, partition, or LUN.

The system returned: (22) Invalid argument The remote host or network may be down. To improve performance when backing up data from a database: Use specific backup agents for the database. Boss: "We're opening an office in another town for Sales, Marketing, and Engineering. Use a dedicated disk array or upgrade to RAID 5.

Elevator: The part of the robotics assembly that moves in the vertical direction. top top Service and repair Removing stuck tapes from slots NOTE: Contact an HP support representative if a cartridge is stuck in the drive.